Bosch says the threaded hole on its miter guage is for after market clamps, etc., but I can’t locate any hold downs other than whole miter guages. I don’t want to spend more than -20.
Is there an easy way to improvise such a hold down for cross-cuts ?
‘

Im in the market and my biggest concern is fit and finish .
I do custom trim, cabinets, doors, exc.. my old dewalt is on its way out and I dont like the new dewalts that I have seen and tried. Im thinking, makita, ridgid, or maybe bosch. I need something that can cut consistent accurate miters. any suggestions from experience would be great.
thanks for your time.

[ReviewAZON asin="B0006FS6CS" display="fullpost"]

[ReviewAZON asin="B0000223FA" display="fullpost"]

[ReviewAZON asin="B002DPVB3K" display="fullpost"]

[ReviewAZON asin="B0007LQPTC" display="fullpost"]

[ReviewAZON asin="B0007LQPUQ" display="fullpost"]

Im installing my 12" Bosch sliding compound miter saw on a Ridged portable work stand. Im sceptical about using the whinny mounting screws that Ridgid supplies to hold saw in place. Does anyone have this kind of set up, and give some advise.